Geometric Dimensioning and Tolerancing for Mechanical Design Part 8 ppt
Geometric Dimensioning and Tolerancing for Mechanical Design Part 8 ppt
... PBU Chapter 08 MHBD031-Cogorno-v6.cls April 18, 2006 15:10 144 Chapter Eight 4X Ø. 380 395 4X $ Ø.750 780 a^ .400 430 Section A–A A Ø 3.000 B A A Figure 8- 21 Specifications for holes and counterbores ... opportunity for a shift tolerance as the datum feature departs from MMC toward LMC in the exact amount of such departure. A Section A - A A Ø 3.000 B A ^ .400 430 $ Ø.750 780 4X Ø....
Ngày tải lên: 05/08/2014, 09:20
Geometric Dimensioning and Tolerancing for Mechanical Design Part 6 ppt
... use is subject to the Terms of Use as given at the website. Source: Geometric Dimensioning and Tolerancing for Mechanical Design ... frames so that the two parts will always assemble, datums A and B will meet, and the part can be produced using the most cost-effective design. The pin is machined in a lathe, and the hole is drilled. Downloaded ... size features of the...
Ngày tải lên: 05/08/2014, 09:20