Friction and Lubrication in Mechanical Design Episode 2 Part 6 pot

... in. 2. 565 8 in. 2. 563 7 in. 2. 5 62 0 in. 0.5 766 in. 0 .65 9 in. 12 0.1719 in. 0.3 0.0 021 in. 0.0038 in. Brass Mild steel 8-10 pin rms (10.99947 cm) (4.99 922 8 cm) (2. 6 924 cm) ... (2. 6 924 cm) (9.44 62 cm) (6. 5171 32 cm) (6. 51 1798 cm) (6. 50478 cm) (1. 464 564 cm) (1 .67 3 86 cm) (0.4 36 62 6 cm) (0.005334 cm) (0.00 965...

Ngày tải lên: 05/08/2014, 09:20

... 0.05 76 0. 063 1 0.00 36 0.0 104 0.0007 0.0 020 0 .64 4 0.700 0.93 1 0.994 1 .27 4 1.414 0 .23 8 0.3 36 0.483 0.455 0 .68 6 0.1 96 0. 322 0 .63 0. 72 1 0. 966 0.959 1 .25 3 1. 365 0 .25 2 ... (N/m2) 1 2 3 4 5 6 7 8 9 10 11 12 13 0. 025 1 0.0 361 0. 025 1 0.0 36 1 0. 025 1 0.0 36 1 0 .2 198 0 .2 198 0 .2 198 0.031 I 0.0...

Ngày tải lên: 05/08/2014, 09:20

... 1 .22 , k = 0. 0 26 . Drozdov and Gavrikov [ 171 investigated friction and scoring under conditions of simultaneous rolling and sliding with a roller test machine. The formula for determination ... 94,703, 189,4 06 ,28 4,109, and 378,8 12 N/m; the slide/roll ratios were 0,0.08,0.154,0 .22 2,0.345; the rolling speeds varied from 0.3 to 2. 76 m/s, and the sliding...

Ngày tải lên: 05/08/2014, 09:20

... (12pin.), W = 378,812N/m (21 60 1bf /in. ), 10W30 oil, U1 = 3 .2 m/sec ( 1 26 in. /sec), R = 0. 023 4 m (0. 92 in. ). Figure 7.38 shows calculated coefficient of friction versus sliding/ rolling ... = 27 3. 16 + "C, ml and m2 are kinematic viscosity in centi- &I* cc19 Pcl9 &I* K2 9 c2 * P2 * E2 are replaced by Kc2 * cc2 * Pc2 , Ec2...

Ngày tải lên: 05/08/2014, 09:20