CCNP ISCW Portable Command Guide pdf

... working on a command guide in the same fashion as his previous books for Cisco Press: the Cisco Networking Academy Program CCNA Command Quick Reference and the CCNA Portable Command Guide. The ... multiplex (MUX)-type VCs NOTE: The global default encapsulation option is aal5snap. CCNP ISCW Portable Command Guide Scott Empson Hans Roth 800 East 96th Street Indianapol...

Ngày tải lên: 19/03/2014, 11:20

... chapter provides information and commands concerning the following topics: • The ip classless command • RIP routing: mandatory commands • RIP routing: optional commands • Troubleshooting RIP issues • ... provides information and commands concerning the following topics: • Configuring OSPF: Mandatory commands • Using wildcard masks with OSPF areas • Configuring OSPF: Optional commands — Loopba...

Ngày tải lên: 15/08/2012, 09:10

... entering the no switchport interface configuration command • SVI—A VLAN interface created by using the interface vlan vlan_id global configuration command and, by default, a Layer 3 interface • EtherChannel ... for SLA 10 to start now and continue indefinitely. NOTE: The ip sla schedule command is the same as the SLA schedule command in Chapter 5, “Implementing a Highly Available Netw...

Ngày tải lên: 21/02/2014, 19:20

... exec command or press the Enter key to start the session. The modem InOut command enables both incoming and outgoing calls. The alternative to this command is the default no modem inout command, ... AT commands documented in Table 4-4 are considered “standard” and should work on most modems. A CCNP or CCDP should be familiar with these commands. For many modems on the market today,...

Ngày tải lên: 17/01/2014, 08:20

... ports. The 5000 series uses the slot/port command. The 1900 series uses the type slot/port command. 5000 Series Set-Based Switch You can use the show command to view port statistics on a 5000 ... Switch These switches take the type slot/port command with either the interface command or the show command. The interface command enables you to set interface-specific configurations....

Ngày tải lên: 17/01/2014, 09:20