Tài liệu Configuring Floating Static Routes pptx

... 5: Advanced Routing v2.0 - Lab 3.6.4 Copyright  2001, Cisco Systems, Inc. 3.6.4: Configuring Floating Static Routes Host A 10.0.0.11 /8 Host B 192.168.3.2 /24 Fa0/0 192.168.3.1 /24 S0/1 192.168.2.1 ... has two routes to the 10.0.0.0/8 network, but only one of these routes is advertised by RIP. If you configure the other path statically, using the default administrative dist...

Ngày tải lên: 24/01/2014, 19:20

... following sections: • Configuring MPLS Levels of Control • Configuring MPLS Traffic Engineering • Configuring MPLS Traffic Engineering Paths • Configuring MPLS Virtual Private Networks • Configuring MPLS ... on the PE to CE link. Configuring Multiprotocol Label Switching Configuring MPLS Virtual Private Networks XC-87 Cisco IOS Switching Services Configuration Guide Configuring...

Ngày tải lên: 24/01/2014, 10:20

... - 3 Semester 5: Advanced Routing v2.0 - Lab 3.6.2 Copyright  2001, Cisco Systems, Inc. 3.6.2: Configuring IGRP Host B 192.168.3.2 /24 Fa0/0 192.168.3.1 /24 S0/1 192.168.2.1 /24 S0/0 192.168.1.1 ... settings. Use the show ip route command to verify that the routers are installing two unequal-cost routes to the same destination: Vista#show ip route <output omitted> I 10.0....

Ngày tải lên: 24/01/2014, 19:20

... (loopback 0). Unless you are using IOS version 12.1, RIP automatically propagates statically defined default routes. So, depending on your IOS version, you might need to explicitly configure ... currently uses RIP. The company connects to the Internet via SanJose2, so you decide to configure a static default route on that router. Then you must configure RIP so that it will propagate...

Ngày tải lên: 24/01/2014, 19:20